The BAL leveler was too small for my 15 inch tires. I used a scissors jack to carefully open the ends of the BAL leveler to the point were it would fit around my tires.

Gallery pages: 1

< 1 of 5 >

He Ruide > The BAL leveler was too small for my 15 inch tires. I used a scissors jack to carefully open the ends of the BAL leveler to the point were it would fit around my tires.

He Ruide > It is very important that the BAL leveler screw is greased and kept clean. I use a piece of insulating foam to keep the screw covered when not in use.

He Ruide > This is a close up of the covered screw. I use a large thumb screw to thighten or loosed the clamp. When thightened, I can carry the BAL level by holding the foam.

He Ruide > The BAL leverler is placed under the tire which needs to be raised. The end of the screw needs to placed in a ring at the base of the leveler. The wrench is turned clockwise to raise the tire and anti-clockwise to lower it.

He Ruide > The leveler in a raised position. I use a 18 Volt DeWalt drill to raise and lower the BAL leveler. The attachements include:
1. 1/4" hex to 1/2" square adapter
2. 1/2" extension rod
3. 3/4" socket

The BAL leveler was too small for my 15 inch tires. I used a scissors jack to carefully open the ends of the BAL leveler to the point were it would fit around my tires.

Other sizes: Small • M • L • O • save photo |

Share photo: links, forums, blogs |

Keywords: backup

Gallery pages: 1

< 1 of 5 >

Comments

New comment: Requires approval

Name: Email: Link:

Connect with Facebook

Comment on: | Rating: stars

To foil spammers, enter this code:

in this box: Code unreadable?

Available Feeds | What are feeds?

Gallery Photos:

Atom |

RSS