Valley magnetic hitch aligner. Telescoping poles with magnets, and each has a bright yellow ball on the end. It extends up to 42" and collapses down to 13-1/2" for storage.
While you can use two of these devices, however, I just use one and line it up with the Hummer tire.
Of course you have to remove the hitch lock first.
Alignment with the tire and AC.
Coupler is right above the ball
Just lower the tongue with the drill
,,,,,and we are lock in placed.
Raise the tongue to a high position. Slide the small end of the WDH bar with the sloted side up into the hitch head and slip the chain into the tightener bracket. In my case there are 10 links of chain between the bar and the tightener bracket and this results in the bar being parellel with the ground with in tightener bracket is in place.
This shows the extra links at the end of the chain that is connected to the tightener bracket.
Insert the hitch release handle (rod with yellow tape) and move the tightener upward until it snaps in place
Once the tightener snaps in place remove the hitch release handle.
Slide the chain sway return loop (the section wth blue Ox) over the tightener bracket.
Safety cable from the brake away switch
Attach the break away cable to the "D" ring.