Push the slide out in towards the PUP.
Twist both slide out latches a 180 degrees and push the end in.
Pull the tent material out so that it does not prevent the bunkends from sliding in.
Push up on the tab at for end of the back saver locking mechanism and slide the bed support towards you and away from the bumper. Attach it to the snap under the bed.
Close up of the back saving locking mechanism.
Release the bungee cord from the tenting material.
Tent material away from under the bed and bed supports stored in place.
Manually cranking down the roof.
The leveler in a raised position. I use a 18 Volt DeWalt drill to raise and lower the BAL leveler. The attachements include:
1. 1/4" hex to 1/2" square adapter
2. 1/2" extension rod
3. 3/4" socket
The BAL leverler is placed under the tire which needs to be raised. The end of the screw needs to placed in a ring at the based of the leverler. The wrench is turned clockwise to raise the tire and anti-clockwise to lower it.